Death Star Hologram Made Using A Raspberry Pi

    raspberry pi   

by editor : Be the first to leave a comment

News is flooding the interweb of an MEng. Group Project and The University of Leeds where four students spent 15 weeks building an interactive globe from the ground up based around a Raspberry Pi dev board and a Xilinx Spartan 6 FPGA.

The globe was build from entirely surface mount components and all the electronics (apart from the RasPi) were designed by them as part of the project.

The Raspberry Pi is mounted at the centre of the display. It is then connected to the FPGA chip via its HDMI output, which is then decoded and converted into RGB data. The image is then scaled down to fit on the display.

The Raspberry Pi is controlled via an iPhone application that we wrote which connects via a Wi-Pi module. The Pi is setup as a router allowing multiple iOS devices to connect at the same time. There is a second Wi-Pi module which connects to eduroam for internet access.

Enhanced by Zemanta

leave a comment


Your email address will not be published. Required fields are marked *